Digi IX10 User Manual

Revision Date Description
downloading cellular modem and device firmware.
l
Added cellular carrier name and PLMN ID to the
Modems Status page in the Web UI.
l
Enhanced access technology options to set the
modem to 5G-only, including setting to 5G SA-only,
NSA-only, or both NSA/SA-modes.
n
VPN enhancements:
l
Added Dynamic Multipoint VPN (DMVPN) support.
l
Added a Strict routing setting to IPsec tunnels that
routes packets through the tunnel if both the
source IP and destination IP match the IPsec
tunnel’s policies. This makes IPsec behave like a
policy-based VPN, rather than a route-based VPN.
l
Added the Microsoft version of the Challenge-
Handshake Authentication Protocol (MS-CHAPv2) as
an option for L2TP network servers authentication
methods.
n
Container support:
l
Container support now a premium feature, enabled
through Digi Remote Manager.
l
Added new metrics for sending container status,
name, CPU load, and disk usage as datapoints to
DigiRM.
n
Added support for running a PPPoE server when an
interface is in IP passthrough mode.
n
Added ability to specify DFS channels for Wi-Fi client
background scanning when DFS client support is
enabled.
n
Added a show eth Admin CLI command to show the
link status of each Ethernet port.
n
Added a poweroff CLI command to perform a graceful
shutdown of the device without automatically
rebooting.
n
Added the ability to turn off all LEDs on the device to
reduce power consumption.
K December 2022
Release of Digi IX10 firmware version 22.11:
n
Updated the Linux kernel to version 5.19.
n
The intelliFlow feature now integrates with Digi Remote
Manager to provide aggregated insights and analytics
for all Digi devices in your environment.
n
Added an MQTTbroker service, including support for:
IX10 User Guide
4

Digi IX10 Specifications

General

Brand	Digi
Model	IX10
Category	Network Router
Language	English