Digi IX10 User Manual

Applications Develop Python applications
IX10 User Guide
621
4. Use config.load(writable=True) to enable write mode for the configuration:
>>> cfg = config.load(writable=True)
>>>
5. Use the set() method to make changes to the configuration:
>>> cfg.set("system.name", "New-Name")
>>>
6. Use the commit() method to save the changes:
>>> cfg.commit()
True
>>>
7. Use the get() method to verify the change:
>>> print(cfg.get("system.name"))
New-Name
>>>
Help for using Python to read and modify device configuration
Get help for reading and modifying the device configuration by accessing help for digidevice.config:
1. Select a device in Remote Manager that is configured to allow shell access to the admin user,
and click Actions > Open Console. Alternatively, log into the IX10 local command line as a user
with shell access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type shell to access the device shell.
2. At the shell prompt, use the python command with no parameters to enter an interactive
Python session:
# python
Python 3.10.1 (main, Mar 30 2023, 23:47:13) [GCC 11.2.0] on linux
Type "help", "copyright", "credits" or "license" for more information.
>>>
3. Import the config submodule:
>>> from digidevice import config
>>>
4. Use the help command with config:
>>> help(config)
Help on module acl.config in acl:
NAME
acl.config - Python interface to ACL configuration (libconfig).
...
5. Use Ctrl-D to exit the Python session. You can also exit the session using exit() or quit().

Digi IX10 Specifications

General

Brand	Digi
Model	IX10
Category	Network Router
Language	English