Containers Use Digi Remote Manager to deploy and run containers
IX10 User Guide
790
c. For the Automation step:
i. Click to toggle on Enable Scanning.
ii. Click to toggle on Remediate.
2. Run a manual configuration scan to apply the container and configuration settings to all
applicable devices.
3. Verify that the container is running on a device:
n
To verify by using device metrics:
a. From the Remote Manager main menu, click Management > Devices.
b. Click the Device IDto open the device's Details page..
c. Click Metrics.
d. Information about configured containers is located under the Container Details
heading.
n
To verify by using the Data streams page:
a. From the Remote Manager main menu, click Management > Data Streams.
b. Locate the container's data stream:
i. Click to search using advance filtering.
ii. Click in the search text bar and select Device IDfrom the menu.
iii. Type the device IDand press the Enter key.
iv. Click in the search text bar again and select Stream IDfrom the menu.
v. Type container and press the Enter key.
To Next Page
Loading...
Need help?
General
