Containers Configure a container
IX10 User Guide
797
(config system container name)> restart_timeout 600s
(config system container name)>
The default timeout of 0s means that if the container stops, it will not be restarted.
8. Type any optional parameters for the container:
(config system container name)> args parameters
(config system container name)>
Parameters are in the format accepted by the lxc utility.
9. (Optional) Set any system directories that should be mounted inside the container. Any
mounted directories need to be accessible to a non-privileged user.
a. Add a system directory to be mounted:
(config system container name)> system_dirs directory
(config system container name)>
where directory is the pathname of the directory to be mounted. The leading slash should
be removed, so for example to mount the /opt directory, type opt.
b. Repeat for additional directories.
10. For Add Directory, click .
a. For Directory, type the pathname of the directory to be mounted. The leading slash
should be removed, so for example to mount the /opt directory, type opt.
11. (Optional) Assign serial ports that the container will have access to:
a. Determine available serial ports:
(config system container name)> ... serial
Serial
Additional Configuration
---------------------------------------------------------------------
----------
port1 Port 1
...
(config system container name)>
b. Add the port:
(config system container name)> add ports end port1
(config system container name)>
12. Save the configuration and apply the change:
(config network wireless client new_client)> save
Configuration saved.
>
To Next Page
Loading...
Need help?
General
