EasyManuals Logo

Digi IX10 User Manual

Digi IX10
996 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
Interfaces Wireless Wide Area Networks (WWANs)
IX10 User Guide
80
o
hostname: The hostname or IP address of an external server.
o
Set ping_host to the hostname or IP address of the server:
(config network interface my_wwan surelink tests 1)>
ping_host hostname/IP_address
(config network interface my_wwan surelink tests 1)>
o
interface_gateway. If set, an initial traceroute is sent to the hostname or IP
address configured in the SureLink advanced settings, and then the first hop
in that route is used for the ping test.
o
interface_address.
o
interface_dns: The interface's DNS server.
l
Set the number of bytes to send as part of the ping payload:
(config network interface my_wwan ipsec tunnel ipsec_example
surelink tests 1)> ping_size int
(config network interface my_wwan surelink tests 1)>
n
dns: Performs a DNS query to the named DNS server.
If dns is set, set the IPv4 or IPv6 address of the DNS server:
(config network interface my_wwan surelink tests 1)> dns_server
IP_address
(config network interface my_wwan surelink tests 1)>
n
http: Uses HTTP(s) GET requests to determine connectivity to the configured web
server.
If http is set, set the URLof the web server.
(config network interface my_wwan surelink tests 1)> http url
(config network interface my_wwan surelink tests 1)>
n
dns_configured: Tests communication with DNS servers that are either provided by
DHCP, or statically configured for this interface.
n
interface_up: Tests the current status of the interface. The test fails if the interface
is down. Failing this test infers that all other tests fail.
If interface_up is set, complete the following:
l
Set the amount of time that the interface is down before the test can be
considered to have failed.
(config network interface my_wwan surelink tests 1)>
interface_down_time value
(config network interface my_wwan surelink tests 1)>
where value is any number of weeks, days, hours, minutes, or seconds, and
takes the format number{w|d|h|m|s}.
For example, to set interface_down_time to ten minutes, enter either 10m or
600s:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi IX10 and is the answer not in the manual?

Digi IX10 Specifications

General IconGeneral
BrandDigi
ModelIX10
CategoryNetwork Router
LanguageEnglish

Related product manuals