Digi IX10

System administration Configure a power profile
IX10 User Guide
832
n
198000
n
396000
n
528000
n
792000
The default is 792000.
5. Set leds_enabled to false to disable all LEDs on the device except for the Power LED, which
will remain lit green, indicating that the device has power:
(config)> system power leds_enabled false
(config)>
If disabled, one or more LEDs will flash periodically to indicate that the device is still active.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.