90030500B Remote Configuration Page 185
TFTP Error Messages on PortServer II
If a TFTP error occurs while booting, the host returns an error message, which PortS-
erver II displays on the alphanumeric display on the front panel. This message will be
in the format
Fn
, where
Fn
can be one of the following:
If a TFTP error occurs:
1. Check that the remote host system supports TFTP.
2. Repeat the TFTP command.
3. If the problem reoccurs:
a. Press the arrow keys (
<
and
>
) on PortServer II’s front panel to reboot from
internal Flash ROM
b. Repeat the configuration command
set host
to ensure that the host’s IP
address, and the path and file name of the configuration file are correct. The
syntax for
set host
is given in the
Command Reference Guide
.
If the problem continues, you may have a system or network incompatibility that pre-
vents the use of TFTP.
F0
Error not defined, see error message (if any)
F1
File not found
F2
Access Violation
F3
Disk Full or allocation exceeded
F4
Illegal TFTP operation
F5
Unknown transfer ID
F6
File already exists
F7
No such user
To Next Page
Loading...
Need help?
General