Digi PortServer II

90030500B Basic Configuration Page 57
Editing keystrokes
You can use any of the following keystrokes when entering commands at the
PortServer II command line:
Ctrl + b
Move the cursor left (move back)
Ctrl + f
Move the cursor right (move forward)
<
--
Erase (delete character to the left of the cursor)
Delete
Delete the character under cursor
Ctrl + h
Delete the character to the left of the cursor. (You can change “h”
to another character with the
set keys
command, as described in
the
Command Reference Guide
.)
Ctrl+p
When typed as the first character on a line, this sequence copies
the previous line from the command buffer onto the current line.
Ctrl+n
When typed as the first character on a line, this sequence copies
the next line from the command buffer onto the current line.
Enter
Executes the currently typed command.
Ctrl [ Enter
Escape character. Used to break out of the current session, either
to another session or to the PortServer II command line.
(You can
change “[” to another character with the
set keys
command, as
described in the
Command Reference Guide
.)
Ctrl+c
Interrupt character. (You can change “c” to another character with
the
set keys
command, as described in the
Command Reference
Guide
.)