Digi PortServer II

Page 224 Troubleshooting 90030500B
5) LMI status change: deleting PVC <dlci>
The DCE has informed PortServer II that the unused
<dlci>
is no longer valid.
6) LMI Status change: PVC <dlci> bandwidth is <bps>
An LMI Rev1 flow control message has been received to change the bandwidth to the
value
<bps>
.
7) LMI status change: PVC <dlci> added
The DCE has informed PortServer II of a new PVC
<dlci>
.
8) LMI fault event: status response not received
A no status response fault event has occurred.
Telnet Messages
(
Option=telnet
)
1) Fail to turn of escape character recognition
*Internal error*
2) Fail to set Binary mode
*Internal error*
IP Messages
(
Option=ip
)
1) packet discarded from interface <name>: header error
An error was detected in the IP header from interface
<name>
. If the problem contin-
ues, use the Trace Debug command to identify the cause.
2) packet discarded from interface <name>: not a router
The PortServer II is not configured as a router and a packet to be routed was received.
3) packet discarded from interface <name>: source route failure
The PortServer II is not defined as a router and a packet to be routed using source
routing was received.