Digi PortServer II

Page 232 Troubleshooting 90030500B
2) (<port>) Bad IPCP_CFG packet
*Internal error*
3) (<port>) bad auth configure packet
*Internal error*
4) cid(<port>): Dropping <n> bytes: packet is too large
*Internal error* (The higher level protocol tried to send a packet too large for the con-
figured MTU).
5) cid(<port>): Dropping <n> bytes: Network layer is down
PortServer II was attempting to send data before a network connection is established.
6) cid(<port>) discard partial packet
A packet was discarded because it is too small to be a PPP frame. This can happen
when PortServer II is shifting into PPP mode at the beginning of a connection.
7) cid(<port>) Dropping <n> byte packet - Network layer down
A data packet was received before PPP negotiations were finished.
VJ (Van Jacobsen) Messages
(
Option=IP
)
1) IP Header Short
A packet was discarded because it is too small to be an IP packet.
2) IP header with no TCP payload
A packet was discarded because it appears to be an IP packet carrying TCP data, yet is
not long enough to hold the TCP header.
13) Cid(<port>) unknown message type (<num>) ignored
*Internal error*