Digi PortServer II

90030500B Basic Configuration Page 63
Note:
If you do not have a Domain Name Server, you can use the PortServer II’s
set host
command to build a table of names and IP addresses. (See the
Command Reference Guide
for the command syntax.)
5. Set your network sub-net mask, using the following command:
#>set config submask=xxx.xxx.xxx.xxx
For example to set the mask to 255.255.255.240, enter:
#>set config submask=255.255.255.240
#>
Note:
The default submask is 255.255.255.0.
6. If you have a gateway, set its IP address, using the following command:
#>set config gateway=xxx.xxx.xxx.xxx
For example, to set the gateway address to 198.83.159.3, enter:
#>set config gateway=198.83.159.3
#>
7. Check the time and date, by entering:
set time
Check that the correct time and date are displayed. If the correct values are not
displayed, enter:
set time time=hour.minute.second date=month.day.year
where the time and date values are the current values, for example:
set time time=11.32.00 date=4.1.96