Page 70 Basic Configuration 90030500B
3. Enter commands to configure the Network parameters for the user, by entering
commands in the format:
set user name=Bill <parameter>=<value>
As in step 2, you can include more than one parameter in each command.
PortServer II displays the list of network parameters that you will configure for
the user. If this is a new user, default settings are provided for the parameters, as
shown below:
User 1 Name=Bill
Network:
IPAddr=123.123.123.123 Protocol=PPP BringUp=Filter_name
IPMask=255.255.255.255 Compression=none KeepUp=Filter_name
LocalIPAddr=123.123.132.132 VJSlots=16 PassPacketFilter_name
NetRouting=receive MTU=1500 LogPacket=Filter_name
PPPAuth=both Passive=off Dialout=off
PapID=identifier AddrCompress=off LocalBusyDly=01
PapPasswd=password ProtoCompress=off RmtBusyDly=01
ChapID=identifier DownDly=01
ChapKey=key_value Device=device_name
LoginScript=script_name
index phonenumber parameters
1 470-9777 ppnx1
2 470-9778 midnight
3
4
5
6
7
8
9
The Network parameters are as follows:
SessionTime-
out
The maximum time in seconds for which the user may be con-
nected before the user is disconnected.
0
means there is no limit.
AddrCompress
If set to
on
, PortServer II attempts to negotiate address
compression on any PPP connection. If set to
off
, no
negotiation is attempted.
BringUp
The name of a BringUp filter that PortServer II will use
to initiate a remote connection. See
Chapter 9, Config-
uring Modem Connections
for information on filters.
To Next Page
Loading...
Need help?
General