Digi PortServer II

90030500B Basic Configuration Page 73
Note:
For information on the Frame Relay parameters attached to the Network
options, refer to
Chapter 14, Configuring Frame Relay
.
pappasswd
The PAP password that PortServer II will send to a
remote system if requested. (Any password that the
remote system returns must match the user’s password.)
Passive
If set to
on
, PortServer II waits for the remote system to
begin PPP negotiations. If set to
off
, PortServer II may
initiate negotiations.
PassPacket
If you enter the name of a filter, any packets not passing
the filter are blocked by PortServer II. See
Chapter 9,
Configuring Modem Connections
for information on
filters.
PPPAuth
If set to
none
, the remote system is not authenticated. If
set to
PAP
, the remote system is authenticated with PAP.
If set to
CHAP
, the remote system is authenticated with
CHAP. If set to
both
, the remote system negotiates
what authentication is used.
Protocol
Sets the protocol on the connection, and may be
PPP
,
SLIP
, or
FR
(Frame Relay).
ProtoCompress
If set to
on
, PortServer II tries to negotiate protocol
compression. If set to
off
, no protocol compression is
attempted.
RmtBusyDly
Sets the number of seconds that PortServer II delays
before trying to establish a connection to a host that is
reported as busy.
VJSlots
Sets the maximum number of slots to use for Van Jacob-
sen header compression (see
Compression
above). Each
active TCP transaction on a point-to-point connection
requires one VJ slot to hold information about the com-
pression state. If there are more transactions than slots,
some compression information is lost.