EasyManuals Logo

Digi XBee Product Manual

Digi XBee
105 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
Command reference tables
XBee / XBee-PRO RF Modules 802.15.4 Product Manual 46
A1
(v1.x80*)
Networking
{Association}
End Device Association. Set/Read End Device
association options.
bit 0 - ReassignPanID
0 - Will only associate with Coordinator operating on
PAN ID that matches module ID
1 - May associate with Coordinator operating on any
PAN ID
bit 1 - ReassignChannel
0 - Will only associate with Coordinator operating on
matching CH Channel setting
1 - May associate with Coordinator operating on any
Channel
bit 2 - AutoAssociate
0 - Device will not attempt Association
1 - Device attempts Association until success
Note This bit is used only for Non-Beacon systems.
End Devices in Beacon-enabled system must always
associate to a Coordinator
bit 3 - PollCoordOnPinWake
0 - Pin Wake will not poll the Coordinator for indirect
(pending) data
1 - Pin Wake will send Poll Request to Coordinator to
extract any pending data bits 4 - 7 are reserved
0 - 0x0F
[bitfield]
0
A2
(v1.x80*)
Networking
{Association}
Coordinator Association. Set/Read Coordinator
association options.
bit 0 - ReassignPanID
0 - Coordinator will not perform Active Scan to
locate available PAN ID. It will operate on ID (PAN
ID).
1 - Coordinator will perform Active Scan to
determine an available ID (PAN ID). If a PAN ID
conflict is found, the ID parameter will change.
bit 1 - ReassignChannel -
0 - Coordinator will not perform Energy Scan to
determine free channel. It will operate on the
channel determined by the CH parameter.
1 - Coordinator will perform Energy Scan to find a
free channel, then operate on that channel.
bit 2 - AllowAssociation -
0 - Coordinator will not allow any devices to
associate to it.
1 - Coordinator will allow devices to associate to it.
bits 3 - 7 are reserved
0 - 7 [bitfield] 0
Table 11: XBee / XBee-PRO commands - networking and security; sub-categories are designated within {brackets}
AT
Command
Command
Category Name and Description
Parameter
Range Default

Table of Contents

Other manuals for Digi XBee

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi XBee and is the answer not in the manual?

Digi XBee Specifications

General IconGeneral
Operating Frequency2.4 GHz
RF Data Rate250 kbps
ModelXBee S2C
CategoryControl Unit
Operating Voltage2.1 to 3.6V DC
Operating Temperature-40 to +85 °C
InterfaceUART
Dimensions24.38 x 27.61 x 9.14 mm

Related product manuals