Digital Equipment VR320 - Removing the Video Casting

3–34 Removing and Replacing FRUs
10. Loosen the two spring-loaded captive screws until they spring
out towards you (Figure 3–29). The screws hold the video casting
assembly to the chassis.
11. Gently pull the top of the video casting assembly toward you.
12. Gently lift the video enclosure assembly up and out of the chassis.
MA-1034-89.DG
Video Casting
Assembly
Spring-loaded
Captive Screw (2)
Figure 3–29 Removing the Video Casting
CAUTION
When you install the video casting assembly, carefully, but firmly,
push the CRT socket connector onto the CRT neck until it stops.
Use care not to bend the pins during this procedure.
When replacing FRUs, install the video casting assembly before
installing the power supply.