Digital Projection E-Vision Laser 5000 XGA - RS232 by Telnet Function; Quick Start-Guide for “RS232 by TELNET”

Digital Projection
E-VISION LASER 5000 SERIES USER MANUAL REV A JANUARY 2018
53
RS232 by Telnet Function
The projector can be controlled by dedicated protocol commands via the RS232 interface with “Hyper-
Terminal” communication.
There is also available an alternative RS232 control, so called “RS232 by TELNET” for the LAN/RJ45
interface.
Quick Start-Guide for “RS232 by TELNET”
Check and note the IP address from the projectors OSD.
Make sure that the connected laptop/PC can access the web-page of the projector via LAN.
Make sure that “Windows Firewall” settings are disabled in case of any “TELNET” function filtering by
the laptop/PC.
On the Laptop/PC choose: Start => All Programs => Accessories => Command Prompt