page 4
Digital Projection M-Vision Laser 18K Series
Installation and Quick-Start Guide
CONNECTING THE POWER SUPPLY
Rev D October 2019
Connecting The Power Supply
Firmly push the mains connector into the socket
1
, then press the ON/OFF switch
2
.
Notes
Use only the power cable
provided.
Ensure that the power outlet
includes a ground connection as
this equipment MUST be earthed.
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.
When operating on 110V Light
output power is reduced by approx
35%.
1 2
To Next Page
Loading...
