page 17
Digital Projection M-Vision Laser 18K Series
Installation and Quick-Start Guide
CHANGING THE LENS
Rev D October 2019
Changing The Lens
Inserting a new lens
1. Remove the front and rear lens caps.
2. Insert the lens, keeping the connector in upright position.
3. Rotate the lens clockwise until it clicks into place.
Notes
Before changing the lens,
always make sure the projector
is switched off and fully
disconnected from its power
supply.
When changing the lens, avoid
using excessive force as this may
damage the equipment.
The lens is shipped separately.
Take care to preserve the original
lens packaging and protective caps
for future use.
The projector will not power on
without the lens fi tted.
To Next Page
Loading...
Need help?
General
