Digital Projection M-Vision 18K Series User Manual

page 68
Digital Projection M-Vision Laser 18K Series
Operating Guide
USING THE PROJECTOR
Rev D October 2019
Setup menu continued from previous page
• Trigger1 and Trigger 2
Choose from Screen, 5:4, 4:3, 16:10, 16:9, 1.88, 2.35, TheaterScope, Source,
Unscaled or RS232 to determine what will cause each trigger output to activate.
• Infrared Remote
Set to Off if you wish to disable the remote control.
• IR Code
The projector and the remote control need a matching IR code: a two-digit number
between 00 and 99.
The default IR code is 00. This is also a master code, which, if assigned to a remote,
will work regardless of the value assigned to the projector.
To assign an IR code for the projector:
1. Select
IR Code.
2. Use the
UP and DOWN arrow buttons to change the values.
To assign an IR code for the remote:
1. Press and hold the
ADDR button on the remote until the indicator starts fl ashing.
2. Release the
ADDR button and while the indicator is still fl ashing, enter a two-
digit address using the numeric input buttons. The indicator will fl ash three times
quickly to confi rm the change.
• IR Code Reset
Use this command to unassign an IR code from the projector. This will revert the IR
Code value to 00.
To unassign an IR code from the remote control,
• Press and hold ALT and ADDR simultaneously until the indicator fl ashes to
confi rm the change.
• Memory
Access this submenu to save up to four presets containing custom combinations of
image settings, or to recall a saved preset.
• Image Latency
Choose either Normal or Fast.
Fast off ers reduced latency for both 2D and 3D sources. Normal should be used in
cases where large amounts of geometry or warp have been applied.
Highlight the UP arrow at the top of the page and press ENTER/OK to go back to the
fi rst Setup menu page.
Notes
If you turn the remote control off ,
you can only turn it back on again
from the control panel or via the
Projector Controller application.
The Projector Controller software
is available for download from the
Digital Projection website, free of
charge.
A wired remote control will also be
disabled if
Infrared Remote is set
to Off.
Setup
Infrared Remote
IR Code
IR Code Reset
Memory
S
On
0
X
Trigger-2 Off
Trigger-1 Off
Image Latency Normal

Digital Projection M-Vision 18K Series Specifications

General

Brand	Digital Projection
Model	M-Vision 18K Series
Category	Projector
Language	English