EasyManuals Logo

Digitalchina Networks DCS-3950 series User Manual

Digitalchina Networks DCS-3950 series
394 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #236 background imageLoading...
Page #236 background image
226
DCS-3950 series Ethernet switch manual
3) Configure expanded 802.1x function
Command Explanation
Global Mode
dot1x macfilter enable
no dot1x macfilter enable
Enables the 802.1x address filter function
in the switch; the ‘no dot1x macfilter
enable’ command disables the 802.1x
address filter function.
dot1x accept-mac <mac-address>
[interface <interface-name>]
no dot1x accept-mac
<mac-address> [interface
<interface-name>]
Adds 802.1x address filter table entry, the
‘no dot1x accept-mac’ command deletes
802.1x filter address table entries.
dot1x eapor enable
no dot1x eapor enable
Enables the EAP relay authentication
function in the switch; the ‘no dot1x eapor
enable’ command sets EAP local end
authentication.
dot1x unicast enable
no dot1x unicast enable
Enable the 802.1x single-cast
authentication function of the switch; the
‘no dot1x unicast enable’ command is used
to diable the802.1x single-cast
authentication function.
dot1x BPDU_forward enable
no dot1x BPDU_forward enable
Enable the 802.1x traversal function of the
switch; the ‘no dot1x BPDU_forward enable
‘ command is used to diable the 802.1x
traversal function of the switch.
dot1x freevlan <vlanID>
no dot1x freevlan
Set the 802.1x freevlan of the switch; the’
no dot1x freevlan’ command is used to
dot1x port-method {macbased |
portbased | userbased { standard |
advanced}}
no dot1x port-method
Sets the port access management method;
the ‘no dot1x port-method’ command
restores MAC-based access management.
dot1x max-user macbased
<number>
no dot1x max-user macbased
Sets the maximum number of access users
for the specified port; the ‘no dot1x
max-user macbased’ command restores the
default setting of allowing 1 user.
dot1x max-user userbased
<number>
no dot1x max-user userbased
Set the max number of the users allowed to
access by specified port, applied to ports
using userbased access control mode; the
‘ no dot1x max-user userbased ‘ command
is used to reset the default value: allowing 10
users at most.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digitalchina Networks DCS-3950 series and is the answer not in the manual?

Digitalchina Networks DCS-3950 series Specifications

General IconGeneral
BrandDigitalchina Networks
ModelDCS-3950 series
CategoryNetwork Router
LanguageEnglish