DINO 240RXT
25
1. The electric motor is automatically switched off in 5 seconds after the execution of the
movement ends.
4. Driving
Make sure that the boom rests on the support and that the outriggers are in the upper position.
The right control lever is used for driving. To drive straight ahead, push or pull the control lever. The
swing movement is controlled with the same lever by moving it in the desired direction..
1. Depress the pedal. Note! None of the movements may be activated while the pedal switch is
pressed down.
If the pedal is kept depressed for more than 10 seconds, and none of the movements is
activated during this time > the pedal must be released and re-activated.
2. Activate the desired movement using the control lever.
3. The engine speed will automatically be increased as soon as the control lever is deflected
from the centre position.
4. When the driving is finished, the engine speed will automatically drop to idling speed.
Selection of the driving speed
1. The driving speed of the machine can be adjusted steplessly with the movement of the control
lever.
Moreover, it is possible to engage the lower speed for driving in rough terrain.
2. The driving speed is selected by pressing the "rabbit" or "tortoise" side of the rocker switch on
the right control lever.
3. The lower speed is selected by depressing the button 3 (tortoise).
4. The higher speed is selected by depressing the button 4 (rabbit).
Selection of the steering mode
1. The steering mode is selected with a turn switch.
2. 3 different steering modes can be selected.
2.1. Position 1 = 2-wheel steering. Only the foremost wheels turn.
2.2. Position 2 = 4-wheel steering. The front and rear wheels turn in opposite directions.
2.3. Position 3 = crab steering. All wheels turn in the same direction.
The steering angle of the rear axle is adjusted in accordance with the front axle..
If the rear axle is left behind, it strives to resume the balance angle difference between the axles. For this
reason, the movement speed may be different while the axles are turning.
As different steering modes are engaged, the wheels on the rear axle will automatically assume the
default position according to the selected steering mode.
Driving with the boom raised (to overcome an obstruction in the terrain)
The machine can be driven with the boom raised. When the boom is raised the lower speed is
automatically engaged.
The operations are as follows:
1. The raising and lowering of the boom is controlled with the same lever.
1.1. The desired function is selected with buttons 1 and 2.
1.2. For selecting the raising/lowering of the boom, push down button 1 on the control
lever.
1.3. For selecting the driving, push down button 2 at the control lever.
2. Push the button S26 (driving with the boom raised) and keep it depressed.
3. Raising/lowering the boom (as desired, it can be raised to a horizontal position).
To Next Page
Loading...
