Dnepr MT10-36 - Storage

.List of compulso ry maintenance jobs
Tools and
accessories
to be used
Continued
Materials used
in maintenance
Lubricate the universal joint
Grease gun Lithol-24
9
Take off and
dismantle the centrifuge
and clean it of dirt
Lubricate the adjusting cone, rear bra-
ke tappets
Lubricate the control cables
Driver's
tools
Driver's
tools, grea-
se gun
STORAGE
GOST 21150-75
Lithol-24
8
GOST 21150-75
Oil AC-8
GOST 10541-63
When preparing the motorcycle for storage in winter time pro-
ceed as follo ws :
carefully clean the motorcycle of dust and dirt and wash it;
thoroughly wipe off all the surfaces; remove traces of corrosion
.and paint the points where the paint has been damaged;
fully prime the fuel tank with petrol, shut off the cock;
start the engme and consume completely the petrol from the car-
burettor float chamber.s;
unscrew the plugs and pour 25 - 30 cm
3
of AC-8 oil into each cy-
linder. Turn the crankshaft through 10-15 revolutions by dep>fes-
sing the starting mechanism lever pedal, following which screw in
the plugs again;
coat all chromium - and tin - plated surfaces with preservation
grease; make use as preservation grease petrolatum or the follow-
ing protective compound: 20% colophony, 30% varnish No. 177;
50% white spirit. Wrap the silencer outlet holes with oiled paper;
put the motorcycle on supports (blocks) and reduce pressure in
the tyres down to 0.5-1 kgf/cm2.
Do
not sto , re the motorcycle close to acids, alkalis, miner al ferti-
lizers and other aggressive materials.
When storing the motorcycle in winter time in a cold room do
not fail to remove f rom it stora.ge batteries a· nd store t hem · separate-
ly in compliance with their maintenance instmcti-ons shipped
complete with the motorcycle.
89