CT100 series inverters Installation and wiring
43
Figure 3-24 Wiring of PNP type source current
Note: Be sure to remove the short-circuit plate between +24V and PW and
connect the plate between PW and COM.
By using the external power supply, the wiring of the external controller for the
NPN-type sink current is as shown below:
Figure 3-25 Wiring of NPN type sink current
Note: Be sure to remove the short-circuit plate between +24V and PW.
By using the external power supply, the wiring of the external controller for the
PNP-type source current is as shown below:
To Next Page
Loading...
