CT100 inverter Safety precautions
2
» Only qualified electricians are allowed to perform the installation, otherwise
electric shock may occur.
» Please install the inverter on fire-retardant materials and keep the inverter
away from combustible materials, otherwise a fire may occur.
» Please assemble and tighten the mounting screws of the inverter according
to the regulations, otherwise the inverter may fall off.
» Do not install the inverter in explosive atmospheres, otherwise an explosion
may occur.
» Handle the inverter with care to prevent it falls off and thus causes injury to
your feet or device damage.
» Keep the inverter away from the places with large vibrations, water drops
and direct sunlight.
» When installing the inverter in the cabinet, especially if two or more inverters
are installed in a cabinet, please pay attention to the installation space and
ventilation.
» Take measures to avoid screws, cables and other conductive matters fall
into the inverter during installation.
» Only qualified electricians are allowed to perform the wiring, otherwise
electric shock or device damage may occur.
» Carry out wiring strictly in accordance with this manual, otherwise there is a
risk of electric shock or device damage.
» Ensure all input power supply is disconnected before wiring, otherwise
electric shock may occur.
» Please select all cables, circuit breakers and contactors meeting the national
standards as required by the manual.
» The inverter must be grounded reliably, otherwise electric shock may occur.
» Carry out wiring strictly in accordance with the silk printing instructions and
avoid connecting the input and output wires reversely, otherwise the damage
to the devices may occur.
To Next Page
Loading...
