INTRODUCTION
EPT023558 Issue 1 February 2016 1-9
Peel roller
The peel roller (highlighted in gray below) is mounted under the platen roller
and ensures sufficient contact between backing paper and platen roller for
accurate label feed. The peel roller is necessary for large label rolls, it
extends the safety margins and reduces the maintenance time. When
changing labels, the peel roller must be open. Pull down the handle (arrow)
to open. When the labels have been exchanged; close the peel roller. A
micro switch controls that the peel roller is in locked position. If the peel
roller is not in position, the printer will not start.
Hood
The protective hood (highlighted in gray below) protects the ribbon from
dirt. When changing ribbon, the hood must be removed. Use the handle
and pull out the hood. When the ribbon has been exchanged, put back the
hood. An inductive sensor controls that the hood is in position; otherwise,
the printer will not start.
To Next Page
Loading...
