SAFETY PRECAUTION
2-4 EPT023558 Issue 1 February 2016
PERSONNEL
Only skilled or instructed personnel are allowed to work on the equipment.
The manufacturer declines all responsibility for injury or damage if the
instructions in this manual are not followed.
Personnel are responsible for:
• The equipment and the work area around the equipment
• All personnel in the vicinity of the equipment
• Making sure that all safety devices are fully operational
Personnel must regard all electrical equipment as live. In general, switch off
all electrical connections and compressed air to the Blow applicators
before carrying out maintenance or repair work.
Electricians
Electricians should be certified according to local regulations and have
experience of similar types of installations, proven skills in reading and
working from drawings and cable lists, and knowledge of local safety
regulations regarding automation.
WARNING: Work with the electrical equipment must be performed
only by skilled or instructed technicians.
According to EN 60204-1, 3.28 an instructed person is:
– An individual adequately advised or supervised by a skilled person to
enable that individual to avoid hazards which electricity can create (e.g.
operating and maintenance staff).
According to EN 60204-1, 3.52 a skilled person is:
– An individual with technical knowledge or sufficient experience to enable
that individual to avoid hazards which electricity can create.
To Next Page
Loading...
