OPERATING PROCEDURES
EPT023558 Issue 1 February 2016 5-11
Remove the empty label roll
(1) Open the print head/pressure roller with the print head lifting handle
(2) Open the peel roller.
(3) Remove the empty label roll.
(4) Open the locking mechanism with the
lever.
(5) Pull out the backing paper.
(6) Carefully clean the print head/
pressure roller.
(For details on print head cleaning,
refer to PART 7 : Clean the Print head.
(7) Gently blow any dust or debris away
from the label-gap sensor.
(8) Install a new roll of labels. Follow the
previous instructions.
Change ribbon
Notes: (1) Ensure that the correct outside
ink type ribbon is used.
(2) Ensure that the ribbon re-wind is parallel to the unwind reel.
(3) Always take care to press the reels into place correctly.
Procedure
(1) Lift the print head with the lifting handle and gently ease the ribbon
out sideways.
(2) Turn the knobs anti-clockwise to open. (See illustration below).
(3) Pull out and remove the exhausted ribbon roll and the roll with the
used ribbon.
(4) Move the empty core from the exhausted ribbon roll to the ribbon
take-up.
(5) Carefully clean the print head with cleaning wipes.
(6) Install a new roll of ribbon and thread it through the printer drive
mechanism, as shown on the threading diagrams below.
(7) Do not pass the ribbon through the label-gap sensor, as the printer
will fail to sense the label gap and will feed labels continuously until
switched off.
(8) Turn the knobs clockwise to close. (See illustration below)
(9) Close the print head to the print position.
(10) To position the label correctly, the machine should feed and measure
two to four labels.
To Next Page
Loading...
