OPERATING PROCEDURES
5-12 EPT023558 Issue 1 February 2016
.
Label positioning can be executed in two ways depending on the setup.
• Head close (default & recommended method). Close the print head
and press the Enter button to feed and position the labels.
• Reset/Power up. Press the Reset button to feed and position the
labels.
Ensure that these non-printed labels are automatically fed out.
After auto feed-out, the printer will have measured the length of the labels
and is ready for use.
Ribbon Take-Up
Roll for used ribbon
Ribbon Supply-
Install the new
ribbon roll here
To Next Page
Loading...
