SAFETY PRECAUTION
2-6 EPT023558 Issue 1 February 2016
MACHINE SAFETY DEVICES
Machine Stop or Emergency stop
The Blow applicators are designed for a Machine Stop. The stop can work
as a Machine stop that only stops the Blow applicators. An emergency stop
normally stops both the Blow applicator and a section of the production
line.
The air is switched off immediately and the system is de-pressurized when
activating the machine stop or emergency stop.
To restart the machine after it has been stopped, the Reset button must be
pressed.
When the Reset button is pressed, the air slowly returns to the machine and
it is ready to use. Site specific procedures may be needed to perform
before re-starting equipment after an Emergency stop.
Note: It is recommended to note the position of the Machine Stop button
or Emergency Stop button in order to stop the equipment in case
of danger to people or damage to the equipment.
To Next Page
Loading...
