SAFETY PRECAUTION
EPT023558 Issue 1 February 2016 2-5
GENERAL SAFETY PRECAUTIONS
Maintenance work on the Applicator
Before any maintenance work is done inside the machine, always
remember to:
(1) Stop the Applicator, see section: 3.2 Stopping the Applicator.
(2) Switch off the Applicator’s main switch.
Note: The following instructions are just necessary for work inside
protective covers.
(3) Remove, if necessary, guards and protections.
(4) Verify absence of voltage with a voltmeter.
Remote control
WARNING: The Applicator can be remotely started, stopped and
accessed from a supervision unit or the production
line’s control system. To disable remote start of the
Applicator, disconnect the Applicator according to
instructions (1)-(2) above.
Compressed Air
WARNINGS: (1) Contaminated compressed air may cause
unpredictable behaviour of machine valves.
(2) Do not change the settings of air pressure on the
machine. Higher pressure can result in injury and
may damage equipment.
Liquids
CAUTION: Never pour water or any other liquid onto the equipment.
Cleaning
CAUTION: Never use unapproved solvents on any surface of the
equipment. Use only manufacturer’s approved cleaning
wipes for cleaning.
I
O
To Next Page
Loading...
