OPERATING PROCEDURES
5-6 EPT023558 Issue 1 February 2016
PCU CONTROLS
Enter Set-Up mode.
Confirm values when changed.
Exit a menu without saving (when used instead of Enter).
Go backwards one step in the menu system for each
press.
Go to Previous/Next menu or item.
The buttons also change the displayed value.
Confirm change with Enter key.
Re-starts the print and apply unit.
See the Technical Manual: Advanced maintenance and
Troubleshooting for more information.
A Position Label sequence will take place (blank labels
fed), if the Reset/Power on is selected in the Position
Label configuration.
See the Setup program for more information.
The TEST button prints a grey pattern test label.
It is used for maintenance and Print head performance
tests.
If the test button is pressed longer, it is the chosen label
that is printed instead. The label’s enumeration is not
affected.
The PRINT button is used to print a label.
Depending on the configuration – it can print a new label,
re-print the last printed label, or it can be set not to print.
To Next Page
Loading...
