BASIC MAINTENANCE & TROUBLESHOOTING
7-10 EPT023558 Issue 1 February 2016
The ribbon wrinkles
The ribbon rewind does not operate correctly
Note: Calibration, adjustment or changing of parts on the printer, PCU or
applicator must be done by skilled personnel.
Applicator
Labels do not apply in the correct position:
Note: Calibration, adjustment or changing of parts on the printer, PCU or
applicator must be done by skilled personnel.
POSSIBLE FAULT Action
The ribbon is incorrectly
threaded
Check the threading diagram
Too low friction on the
ribbon supply spool
Adjust the friction clutch
The ribbon guide is not
parallel with the ribbon
Adjust the position of the ribbon guide
Too wide ribbon compared
to the printed area
Change to another ribbon width
The print head is misaligned Contact service personnel
POSSIBLE FAULT Action
The ribbon is incorrectly
threaded
Check the threading diagram
Insufficient spring tension
for the ribbon take-up
Adjust the pressure on the ribbon take-up
roller
The ribbon is dirty Clean the roller thoroughly
POSSIBLE CAUSE Action
The applicator is not aligned Adjust the alignment between the printer
and the applicator
blow box or exchange
applicator if it is damaged.
To Previous Page
Loading...
