LABEL & RIBBON SELECTION
6-4 EPT023558 Issue 1 February 2016
SELECTION OF RIBBON
Type of ribbon
The type of ribbon to be selected is dependent on the label material to be
used, as it is possible to obtain a ribbon to suit virtually any type of label
material.
Contact your supplier for advice on which type of ribbon to use for your
particular application.
Back coating
The ink on the ribbon is important for print quality, but the back coating is
also important to preserve the life of the print head.
A low quality ribbon often has a poor quality back coating that can leave
too much residue on the print head. If the print head is not cleaned
frequently, it will damage the print head.
Do not use low quality ribbon in the printer as this will increase the
maintenance costs.
Ribbon selection overview
T50i
Maximum length 600m
Maximum width 115mm
Maximum outer diameter 90mm
Recommended minimum width 60mm
Core diameter 25 - 26.2mm
Ribbon rolled Ink-out
To Next Page
Loading...
