OPERATING PROCEDURES
5-10 EPT023558 Issue 1 February 2016
Label positioning
CAUTION: Label positioning must always be performed after changing
labels or ribbons.
The label positioning procedure measures the label and stops it in a pre-set
position on the dispensing beak.
The stop position is set by the head distance and the feed length. Both the
head distance and the feed length can be adjusted in the Setup program or
via the PCU front panel.
PCU
The positioning of the label can be executed in two ways depending on the
setup.
• Head close (default & recommended method). Close the print head
and press the ENTER button to feed and position the labels.
• Reset/Power up. Press the RESET button to feed and position the
labels.
After label positioning, the printer/labeller will have measured the length of
the labels and is ready for use.
Note: The labels must pass through the label gap sensor. Otherwise the
printer assumes the label supply is exhausted and will not operate.
To Next Page
Loading...
