Domino M Series - Label Selection from the Front Panel

OPERATING PROCEDURES
5-8 EPT023558 Issue 1 February 2016
Label selection from the Front panel
Label selection from the front panel is not password protected and a label
stored in the printer memory can easily be selected by using the keys on
the front panel.
Follow the steps below:
Make a print and the chosen label will be printed.
Note: A maximum of 500 labels can be selected from the front panel.
Step Action Display Shows
1 Enter the Menu system (level 1) by
pressing the Enter key twice.
LABEL MENU
Select labels
2 Press the Enter key and enter the
label selection menu.
SELECT LABELS
= xxx
xxx = The last used label or the last label in the list of labels that
has been transmitted to the printer memory.
3 Press the Enter key and start
selection.
SELECT LABELS
= xxx (flashing)
4 Use the – and + keys to scroll up and
down in the label list.
5 Press Enter to confirm selection. LABEL MENU
Select labels
6 Press Exit to leave the menu system. PRINTER OK
Ready