OPERATING PROCEDURES
5-4 EPT023558 Issue 1 February 2016
Stop the printer
Open the print head to stop the printer. Use the handle at the side of the
print head.
When the print head is up, no labels can be printed and the machine will not
work.
The printer stops immediately when the print head is opened.
Re-start the printer
See the instruction for changing labels later in this chapter.
APPLICATOR - START / STOP / RE-START
Start apply
A label must be printed or fed before the applicator can start.
The start signal to the applicator can be made by:
• Product detector, or other start signal, to the apply input on the ACC
board.
• Software.
• Automatically when the label is printed.
To Next Page
Loading...
