Dormakaba ED900 - 12 ED900 Installation Overview; Installation Preparation

28
ED900 02-202008125330
dormakaba ED900 Installation Instructions – Double egress door Chapter 12
 ED installation overview
. Installation preparation
WARNING
Review safety information in Chapter 3!
WARNING
ED system should be installed by trained
and knowledgeable installers experienced in
installation and commissioning of swing door
operators.
The installer should be familiar with all
applicable local and national building code
requirements, and with requirements of
current ANSI/BHMA standard A., Power
Assist and Low Energy Power Operated
Doors.
.. dormakaba USA, Inc. ED hardware.
. Locate shipping boxes for ED operator and
hardware.
NOTICE
Installation steps listed in Chapter 14 through 17
are a recommendation. Structural, local
conditions, available tools, or other factors or
circumstances may require modification to
these steps.
.. Door frame and door.
CAUTION
Insure area around door frame, adjacent walls
and door is readily accessible and free of
objects and debris.
.. Accessories
. Verify accessories planned for or in place for the door.
Chapter , system accessories, list typical accessory
types for ED operators.
TIPS AND RECOMMENDATIONS
Accessory wiring to ED operator should be
planned for prior to operator installation.
.. ED mounting plate installation preparation.
CAUTION
Using applicable ED installation template
(Chapter ), holes for mounting plate
fasteners must be located and drilled into door
frame, wall or substructure prior to mounting
plate installation.
CAUTION
Mounting plate installation must be orientated
with  Vac connection towards door hinge side.
.. ED mounting plate extension used with
optional full door width cover.
TIPS AND RECOMMENDATIONS
Mounting plate extension is included
for full width cover installation.
• Reference Chapter .
.. ED  Vac electrical installation.
WARNING
Work on electrical equipment and  Vac
wiring installation must be performed only by
qualified personnel!
WARNING
Electrical shock hazard!  Vac branch circuit
disconnect for ED must be Off prior to
start of electrical installation.
WARNING
115 Vac wiring to ED900 operator must
conform to local and national electrical codes.