49
ED900 02-202008125330
dormakaba ED900 Installation Instructions – Double egress door Chapter 15
.. Select installation template.
. Select applicable installation template.
NOTICE
Installation templates: Reference Chapter .
.. Fasten mounting plates to jamb and/or wall.
CAUTION
Install shims between mounting plates and wall
as required.
CAUTION
ED conduit box (if used):
• Insure ED conduit box
(Para. .) is prepared with applicable
conduit fitting or cord grip.
• Insure jamb or wall is prepared for wiring
to each ED conduit fitting or cord grip.
. Using template as a guide, prepare
twelve mounting holes at first mounting plate
location for mounting plate fasteners (Fig. ..).
. Install first plate.
. Full width cover option: Using mounting plate
extension as a guide, mark four mounting holes for
extension.
. Using template as a guide, prepare
twelve mounting holes at second mounting plate
location for mounting plate fasteners (Fig. ..).
. Install second mounting plate.
. Full width cover option: Install mounting plate
extension.
.. Mounting plate installation checks.
CAUTION
• Check level.
• Check spindle to hinge centerline distance.
• Check mounting plate alignment.
.. Install third guide pin.
. Install third guide pin (Fig. ..) in each mounting
plate (Fig. ..).
• Use mm hex T-handle or hex key.
13
Fig. 15.2.2 Guide pin
13 Guide pin
. Install ED mounting plate to jamb and/or wall
CAUTION
Select fasteners based on door frame and wall
material.
CAUTION
Use fasteners provided with ED (Fig. ..).
Fig. 15.2.1 Mounting plate fasteners
15 1/4-20 x 1" FH
machine screw
16 No. 14 x 1 "FH wood
screw
(12) 15
(12) 16
To Next Page
