Dormakaba ED900 - Install Push Arm Door Stop; Install Push Arm Door Stop (Optional Assembly)

83
ED900 02-202008125330
dormakaba ED900 Installation Instructions – Double egress door Chapter 27
 Install push arm door stop
. Install push arm door stop (optional assembly)
.. Assemble bumper stop.
. Attach bumper to bumper mounting
plate with /" shoulder screw.
• Use  mm hex key.
.. Open door.
. Set program switch to OPEN position.
. Door moves to set opening angle.
WARNING
Use caution when working in
proximity of door and push arm!.
Fig. 27.1.2 Program switch, OPEN position
Fig. 27.1.1 Door stop assembly
4 Bumper stop
assembly
.. Bumper stop installation.
. With door at its full open position locate
door stop assembly bumper on door
frame /" beyond arm.
. Mark mounting plate hole locations on
frame.
• Plate hole diameter is /".
. Select fasteners based on door frame
material.
. Attach door stop assembly to frame.
CAUTION
Using program switch, close then
open door to verify arm does not
contact door stop with door at
full open position.
5.1
5.2
1
3
4
2
Fig. 27.1.4 Door stop installation
6
Door stop assembly
/" thick plate

Door stop assembly
/" thick plate

1 Plate, bumper
mounting,
1/4" thick
08120774
2 Plate, bumper
mounting,
1/2" thick
08120770
3 Rubber bumper
08120750
4 Shoulder bolt
08104231
5.1 1/4-20 x 1 1/4"
Phillips FHS, black
oxide, SS
5.2 No. 14 x 1 1/4"
Phillips FHMS for
sheet metal, zinc
plated steel