67
ED900 02-202008125330
dormakaba ED900 Installation Instructions – Double egress door Chapter 18
. Reveal depth parameter rd
Parameter
Description Reference paragraph
rd
Reveal depth
. rd parameter values
Reveal measurement
Inches [mm] rd
- /" - -
- / - -
-/ - -
-/ - -
*
/
/
/
/
.. ED reveal depths, rd parameter
Reveal measurement
Inches [mm] rd
/
/
/
/
/
/
/
/
/
Parameter rd value Reveal measurement
.. Reveal depth parameter.
. Reveal depth is set in increments of mm
(approximately /").
Example: Measured reveal depth of mm
(approximately /") equals rd parameter value of .
.. Measure reveal depth parameter.
Reveal depth measurement required for each ED
operator.
Reveal measurement
Inches [mm] rd
/
/
/
/
/
/
/
/
Reveal measurement
Inches [mm] rd
/
/
/
/
/
. Measure and record reveal
depth
Fig. 18.4.1 T275 track and pull arm
Fig. 18.3.1 Positive reveal
Fig. 18.3.2 Negative reveal
Mounting surface
Negative reveal
depth
Door face
Door frame
Positive reveal depth
Door
frame
Mounting surface
Door face
*Factory setting
.. Use of T275 track and pull arm (Fig. 18.4.1).
Value of parameter rd must be reduced by /" [].
• Example: ED with T track in pull installation
with reveal of mm ( /").
Parameter rd setting = . (Reveal of mm -
mm).
To Next Page
