Dormakaba ED900 - Connect Customer 115 Vac to ED900 Mounting Plate Terminal Block

52
ED900 02-202008125330
dormakaba ED900 Installation Instructions – Double egress door Chapter 15
. Connect customer  Vac to ED mounting plate terminal block
Fig. 15.4.1 Double door mounting plate installation with standard covers
1 ED900 mounting
plate
3 115 Vac terminal
block
.. ED  Vac electrical
installation.
WARNING
Work on electrical equipment and
 Vac wiring installation must
be performed only by qualified
personnel!
WARNING
Electrical shock hazard!  Vac
branch circuit disconnect for
ED's must be Off prior to
start of electrical installation.
WARNING
115 Vac wiring to ED900 operators
must conform to local and national
electrical codes.
Fig. 15.4.2 Double door mounting plate installation – optional full width cover
1
1
3
3
1 ED900 mounting
plate, inactive door
4 115 Vac terminal
block
2 ED900 mounting
plate, aactive door
.. ED installation with standard
covers.
• Customer  Vac power wiring required
to terminal block () on each mounting
plate (Fig. ..).
.. ED installation with full width
cover option.
• Customer  Vac power wiring required
at terminal block () on inactive door
mounting plate (Fig. ..).
• Active and inactive door assignments
may be reversed from Fig. ..).
12 4
3
5
3 ED900 mounting
plate extension
5 Conduit box (option)