73
ED900 02-202008125330
dormakaba ED900 Installation Instructions – Double egress door Chapter 22
Fig. 22.1.5 T275/Arm with CPD lever and track
.. Configuration parameters, detail.
Fig. 22.1.4 T/Arm with track
Fig. 22.1.6 J/Push arm
Fig. 22.1.7 J8/Deep reveal push arm
Parameter and value
range, factory setting
= bold.
Parameter description
-
Installation type
Pull
• Arm with track (Fig. ..).
• Arm and CPD lever with track
(Fig. ..).
Wall mounting on swing (hinge)
side.
Push
• Standard push arm
(Fig. ..)
Wall mounting on approach
(non-hinge) side.
Push
• Arm with track (Fig. ..).
• Arm and CPD lever with track
(Fig. ..).
Wall mounting on approach
(non-hinge) side.
ED
- to
Reveal depth
Reveal is set in increments of
mm (/"), "" = mm ( /")
• ED: [- to mm]
- /" to /"
If using arm with CPD lever
(Fig. ..), approximately
/" [ mm] must be
deducted from actual reveal.
Tb
ED
to
Door width
Door width is set in increments of
mm ("),;"" = mm (.").
• ED: [ - ] " - "
.. Arm with track – push installation
[Application specific].
. For doors without fire or smoke detection
requirements.
. Maximum reveal depth of /" [].
. Maximum opening width at a reveal depth of
/"[] is reduced to degrees.
.. CPD arm and lever; rd parameter adjustment.
• Value of parameter rd must be reduced by /" []
when using the arm with CPD lever in a pull
installation.
• Example: ED with arm and CPD lever in pull
installation with reveal of mm ( /").
Parameter rd setting = (Reveal of mm - mm).
to
Door type
Single door
Double door
• Overlapping door (with
astragal)
• Active door operator.
Double door
• Overlapping door (with
astragal)
• Passive door operator.
Double door
• Edgeless door (no astragal)
• Active door operator.
Double door
• Edgeless door (no astragal)
• Passive door operator.
To Next Page
Loading...
