Definitions
Symbols
Definitions of Terms
Typing Conventions
Operating Instructions Julian SW 3.n
11
Definitions of Terms
NOTE: A NOTE provides additional information
intended to avoid inconveniences during operation.
Inspection = examination of actual condition
Service = measures to maintain specified
condition
Repair = measures to restore specified
condition
Maintenance = inspection, service, and repair,
where necessary
Preventive = Maintenance measures at regular
Maintenance intervals
Typing Conventions
Controls (knobs, hard keys and menu keys ) are
designated as »Control Name«, e.g.:
»PCV«
On-screen messages are printed in bold, e.g.:
BATTERY LOW !!!
CAUTION !
A CAUTION statement designates the possibility
of damage to equipment if disregarded.
WARNING !
A WARNING statement refers to conditions
with a possibility of personal injury if
disregarded.
Symbols
Symbol Meaning
G Suppress alarm tone for 2 minutes
Q Call up standard screen + escape
S Call up basic screens in succession
E Standby / operation switch
Dial knob for adjusting and confirming
settings
Fresh gas flowing
u Action in progress
✓ Action has been completed successfully
? Repeat calibration
_ Upper and lower alarm limits
> Upper alarm limit only
< Lower alarm limit only
_ Alarm limit disabled
– – Alarm limit deactivated
g Alarm disabled
* * * * Enter 4-digit password
! Advisory message
!! Caution message
!!! Warning message
m Protection class type B
m Protection class type BF
P Connection for equipotential bonding
Refer to important information in
Operating Instructions
z Close menu, back to previous menu
J Available operating capacity of UPS
XX %
To Next Page
Loading...
