Dräger Julian - Configuring in Standby Mode

Contents
Setting Default Values............................................................................. 92
Setting Volume of the Pulse Tone (Optional)..............................................93
Setting Audible Alarm Volume....................................................................93
Selecting the Scale................................................................................... 93
Setting Measuring Parameters...................................................................94
Record......................................................................................................95
Configuring the Interfaces......................................................................... 95
Setting Default Alarm Limits.......................................................................96
Configuring Waveforms (Traces)...............................................................98
Setting Basic Configurations..................................................................... 99
CMV Default Settings..............................................................................100
PCV Default Settings.............................................................................. 100
Setting Fresh Gas Defaults..................................................................... 101
Manual Calibration.................................................................................102
100 Vol.% O2 Calibration....................................................................... 102
O2 Linearity Test..................................................................................... 103
MAC configuration................................................................................. 103
Anesthetic agent identification and display...............................................103
Calculating the MAC values.................................................................... 103
Displaying MAC...................................................................................... 104
Configuring in Standby Mode
Contents
Operating Instructions Julian SW 3.n
91
Configuring in Standby Mode