Dräger Julian - Configuring Waveforms (Traces)

Configuring Waveforms (Traces)
Three standard waveforms can be configured for
each of the ventilation modes: MAN/SPONT, CMV
and PCV.
● Turn dial knob to select the line »curves«,
press to confirm.
The selection menu appears in the left-hand field.
Display (example):
● Select desired ventilation mode with dial knob:
»Default curves CMV« has been selected in the
example:
Currently selected parameters appear in the left-hand
field, followed by the selection menu for selectable
waveforms.
To replace a parameter:
● Select the respective parameter in the selection menu
with dial knob, press to confirm. The parameter
appears against a white background (inversed).
The cursor jumps to the zz
zz
symbol of the positioning
menu.
● Select and confirm position of the new parameter with
dial knob.
NOTE: The corresponding position remains unused if
»blank« is selected.
Configuring in Standby Mode
Setting Default Values
Operating Instructions Julian SW 3.n
98
Standby / Configuration
calibration
Configuration Menu for Screen Displays
default curves Man./Spont.
default curves CMV
default curves PCV
defaults
alarm sound
scale
parameter
record
interface
alarm limits
curves
basic configurations
CMV settings
PCV settings
Fresh Gas Flow Control
0 1 2 3 4 6 7 8 9 5
1 2 3 5 6 7 8 9 4
pls. tone
adult child
MAC-config.
Standby / Configuration
calibration
To select curve position: turn and confirm .
defaults
alarm sound
scale
parameter
record
interface
alarm limits
curves
basic configurations
CMV settings
PCV settings
Fresh Gas Flow Control
0 1 2 3 4 6 7 8 9 5
1 2 3 5 6 7 8 9 4
pls. tone
adult child
MAC-config.
CO
2
PAW
Pressures
Pleth
O
2
AGas
Flow
Volumeter
CO
2
Flow
FG/volu
blank
Volumeter
FG/press
default curves IPPV