Sample gas scavenging
● Use hose 11 90 520, connector M 33 151 and
sealing cap (optional).
1 Connect the hose to the port of the sample gas
outlet port.
2 Attach connector with sleeve to the free end of the
hose.
Insert connector into the coupling of the anesthetic
gas scavenging system until it clicks into place.
3 Install cap to seal the port.
WARNING !
Make sure scavenger hoses are not pinched,
kinked, or blocked in any manner.
Preparation
Assembly of Components
Operating Instructions Julian SW 3.n
32
1
2
3
To Next Page
Loading...
