DSC MAXSYS PC4010 - 3.7 [*][7] Command Outputs 1-8; 3.8 Keypad Control; 3.9 Downloading Options

20
SYSTEM AREA
COMMUNICATOR MAIN ITEMS
Code Message as seen on receiver
24 Hour Non-Burglary
5A QALARMQ - 24 HR. NON-BURG - #
51 QALARMQ - GAS DETECTED - #
52
Q
ALARM
Q
- REFRIGERATION - #
53
Q
ALARM
Q
- HEATING SYSTEM - #
54
Q
ALARM
Q
- WATER LEAKAGE - #
55
Q
ALARM
Q
- FOIL BREAK - #
56
Q
ALARM
Q
- DAY ZONE - #
57
Q
ALARM
Q
- LOW GAS LEVEL - #
58
Q
ALARM
Q
- HIGH TEMPERATURE - #
59
Q
ALARM
Q
- LOW TEMPERATURE - #
61
Q
ALARM
Q
- AIR FLOW - #
The rest of the reporting codes must be programmed as follows or left as FF to be disabled.
Partition Open AA
Partition Close AA
Periodic Test Transmission A2
Quick Arm Closing A8
RS-232 Trouble Alarm 35
RS-232 Trouble Restoral 35
System Test A1
System AC Trouble Restoral A1
System TLM Line 2 Restore 52
System FTC Restoral 54
System TLM Line 2 Trouble 52
System Battery Trouble Restoral A2
System Aux Supply Trouble Alarm AA
System Battery Trouble Alarm A2
System Bell Trouble Alarm 21
System AC Trouble Alarm A1
System Aux Supply Trouble Restoral AA
System TLM Line 1 Restoral 51
System TLM Line 1 Trouble 51
System Bell Trouble Restoral 21
Waterflow Trouble A1
Waterflow Trouble Restoral A1
Zone Fault 44
Zone Fault Restore 44
Zone Low Battery 84
Zone Low Battery Restore 84
Zone Sensor Fault 81
Zone Sensor Fault Restore 81
Zone Tamper 44
Zone Tamper Restore 44
Automation Fault 3A
Automation Fault Resotre 3A
DVAC Trouble 5A
DVAC Trouble Restore 5A
2 Wire Smoke Trouble AA
2 Wire Smoke Restore 11
2nd Master Open A2
2nd Master Close A2
4204 Battery Trouble Restoral 3A
4204 AC Trouble Restoral 3A
4204 Battery Trouble Alarm 3A
4204 Aux Supply Trouble Alarm 3A
4204 Aux Supply Trouble Restoral 3A
4204 AC Trouble Alarm 3A
Access Codes 1 to 128 Closing A2
Access Codes 1 to 128 Opening A2
Auto Arm Abort A5
Automatic Opening A3
Automatic Closing A3
Cellular Trouble Restoral 51
Cellular Trouble 51
COMBUS Trouble Restore 33
COMBUS Trouble Alarm 33
Downloading Lead Out 12
Downloading Lead In 11
Duress 21
Fire Zone Troubles 73
Keypad Lockout 21
Keypad [P] key Restoral 2A
Keypad [F] key Alarm 15
Keypad [A] key Restoral AA
Keypad [A] key Alarm AA
Keypad [F] key Restoral 15
Keypad [P] key Alarm 2A
Keyswitch A9
Links Tx A3
Module Tamper Restoral 45
Module Tamper Alarm 45
Partial Closing 74
Surgard 4/3 DTMF Format
This is a 7 digit format sent by DTMF tones and uses a 2300 Hz handshake. Each round pair
represents a single event as follows:
SSSSXCC
where, SSSS=4 digit account code
X = Event descriptor, preprogrammed in the PC4010.
CC = 2 digit reporting code programmed by the installer.
The reporting codes can be programmed with any hex number from 01 to FE (00 or FF will disable
the reporting code).
Note that both “0” and “A” will both represent and be received as “0”.