DURKOPP ADLER Class 271 - Winding the Underthread

To Next Page

To Previous Page

6.4 Winding the Underthread

–

Place the bobbin on the winder shaft 1.

–

Thread the underthread as shown in the illustration.

–

Wind the underthread clockwise onto the bobbin core.

–

Pull the thread end through the trimming clamp 2 and cut.

–

Swing the winder flap 3 against the bobbin.

–

Turn the main switch on.

–

Start the sewing sequence.

–

After reaching the set bobbin-fill quantity (see Service Instructions), the winder

turns off automatically.