DURKOPP ADLER Class 271 - 7.3.8 Setting the Positions with the V820 control panel; Setting the reference position; Setting positions 1 and 2

7.3.8 Setting the Positions with the V820 control panel
Setting the reference position
Prerequisite:
The code number for the Technician Level is entered. (see Chapter 7.3.7)
–
After entry of the code number press the "
E
" key. The first parameter of the
technician level "
F-100
" is shown.
–
Enter the parameter
F-170
with the keys 0 - 9..
–
Press the "
E
" key. The display shows = "
F-170 Sr1 (o)
"
–
Press the "
B
" key (see illustr. 7.3.1) . The display shows= "
PoS0 o
" (the "
o
"
character rotates).
–
Turn the handwheel in the normal direction of rotation until the rotating character
"
o
" in the display disappears, then continue turning until the reference position
(handwheel in position "
F
") is reached.
–
Press the "
P
" key. The reference position is saved. The current parameter number
is shown.
–
If the error message "
A3
" appears, the setting must be repeated.
–
Press the "
P
" key, the programming at the technician level is ended.
Setting positions 1 and 2
Prerequisite:
The reference position is set and the code number for the Technician Level is entered
(see above).
–
Enter the parameter "
F-171
.
–
Press the "
E
" key. The display shows = "
Sr2 (o)
".
–
Press the "
B
" key (see illustr. 7.3.1) . The display shows "
P1E xxx
".
(xxx = parameter value of the pos. 1E
–
If necessary correct the parameter value * . Either with the "
+
" and "
-
" keys or with
the keys 0 - 9 or by turning the handwheel to position "
F
".
–
Press the "
E
" key. The display shows "
P2E xxx
"
(xxx = parameter value of the pos. 2E).
–
If necessary correct the parameter value * . Either with the "
+
" and "
-
" keys or with
the keys 0 - 9 or by turning the handwheel to position "
C
".
–
Press the "
E
" key. The display shows "
P1A xxx
"
(xxx = parameter value of the pos. 1A).
–
If necessary correct the parameter value * . Either with the "
+
" and "
-
" keys or with
the keys 0 - 9 or by turning the handwheel.
–
Press the "
E
" key. The display shows "
P2A xxx
"
(xxx = parameter value of the pos. 2A)
–
If necessary correct the parameter value * . Either with the "
+
" and "
-
" keys or with
the keys 0 - 9 or by turning the handwheel..
–
Press the "
P
" key twice. The setting is completed and the programming level is
exited.
–
Check positions, see Chapter 6.8
GB
45