DURKOPP ADLER Class 271 - Attaching the Controls; Attaching the Controller; Attaching the Cable Duct; Attaching the Pedal

To Next Page

To Previous Page

5.3 Attaching the Controls

–

Attach the

controls 7

with 4 screws under the table top 5.

–

Fasten the

mains lead

of the controls under the table top with the strain relief

clamp.

5.4 Attaching the Controller

–

Screw on angle 2 under the table top 5.

–

Screw controller 3 to the angle 2.

5.5 Attaching the Cable Duct

–

Screw on cable duct 1 under the table top 5

5.6 Attaching the Pedal

–

Fasten pedal 9 to stand brace 10.

–

For ergonomic reasons pedal 9 is to be aligned sideways as follows:

The pedal center must lie approx. under the needle.

The stand brace 10 is equipped with slots for alignment of the pedal.

–

Hang the pedal rod 8 onto the controller and the pedal 9 with the ball sockets.

–

Loosen screw 4.

–

Set the height of the pedal rod so that the released pedal has an incline of about 10°.

–

Tighten screw 4.